Isometric views showing the front & back of the gripper tool.

An exploded and cross section view to show all the components and how they mate up.

The cam knob has two identical grooves on the internal face. As the knob twists in one direction or the other, one end of the steel pins ride along the path and are forced further apart or together.

The other end of the pins are pressfitted halfway into the gripper fingers. This both provides rigidity to the fingers, while also constraining the movement of each pin to only rotate about their respective pin’s living hinge. As the driven end of the pin is forced apart/together, the gripper fingers move in the opposite manner.

The printed gripper finger with the pins installed.

The printed cam knob. A M1.5 bolt holds the knob to the gripper fingers.

Close up image of the cam knob’s grooves. A bit of wear after being worked in a bit.

Close up view of the gripper fingers.

Backside view of the gripper fingers.

The complete gripper tool assembled!

Gripper actuation demonstration.

Mini Gripper Tool

This is a little tool I designed for a job that required me to hold and align a stack of small parts during an assembly. I had a little time to spare, so decided to see if I can make it a brief but fun side endeavor, and make the thing unnecessarily more complicated! :D
I was already determined to design a functioning gripper, so the challenge came in how to make it small enough while holding up to my abuse.
The concept is fairly simple with the gripper actuating about a living hinge, and is driven by pins and a rotating cam path. I wanted to limit the amount of fab work, so aimed to design cheap off-the-shelf parts with everything else being 3D printable. For the designed parts, I printed them on a Form2 SLA printer using Formlab’s Durable resin, which provided the appropriate balance of durability, wear-resistance, and flexibility for the design.
Overall, satisfied with the design as I enjoyed using it for its designated end use. One thing I would potentially look into improving would be going for a push-button style actuation over a twist-knob.