Machined the center tip with a 60 degree cone to it, and made it to slip fit these skate bearings I had lying around. The double bearing system creates better rigidity for the live center, and also mitigates potential damage to the bearings from misalignment.
Machined the bearing housing and the Morse taper shank our of some mild steel rod stock that were collecting dust. The bearings press fit into the housing along with the housing, retaining all the components.
The taper is a #2 Morse taper with an angle of 1.4307 degrees. Since the mini-lathes compound slide only came in incrementations of 2 degrees per tick, I chucked up a existing taper, and traced it with a dial gauge mounted to the tool post. The compound was tapped into position until the gauge read a total deviation of no more than .0005"
Using a torch, charcoal, and a fan in an attempt to heat treat the parts. Quenched in some motor oil after heated to a dark red glow.
After a quick polishing of the parts and assembly, the live center works great and the morse taper fits snugly into the tailstock quill.
The Morse taper was made from a rod with a keyway in it, and now it doubles as an oiling well for the bearings. Quite convenient, so long as its facing down to prevent chips from going in!
Mini-Lathe Live Center
A Live Center is tool for the lathe that helps you part stay aligned with more rigidity. This is especially beneficial when working with stock that is long and/or thin, which can bend when attempting to make cuts, and can also allow you take more aggressive cuts than your machine will typically handle. Unlike a Dead Center, the Live Center has a tip that spins freely with the help of ball bearings to do away with friction between your part and the centering tool. This project was made entirely by hand (except the ball bearings) with scrap materials lying around, in attempts to test the mini lathe’s capabilities as well as challenge my machining tolerances.
Role |
I made it |
For |
UCLA ASME |
Date |
3/8/2016 |
Type |
For giggles |