Cuttlefish Mk.1 Concept Design
(Rear Isometric View)
Cuttlefish Mk.1
(Side View)
Cuttlefish Mk.2 Concept Design
(Rear Isometric View)
Cuttlefish Mk.2
(Rear View)
Cuttlefish Mk.2
(Front Isometric View)
Cuttlefish Mk.2 crank drive system
Cuttlefish Mk.2 subsystem exploded view
Mk.2.1 Prototype
Mk.2.1 Prototype
(Side View)
Early Mk.2.1 Prototype Concept Demonstration
Mk.2.2 Prototype Chassis
Mk.2.2 Prototype drive parts
Mk.2.2 Prototype Assembly
Mk.2.2 Prototype Assembly
Mk.2.2 Test Video: binding issues
Mk.2.3 Chassis Revision
Mk.2.3 Pivot Joint Revision
Mk.2.3 Post-Assembly Manual Test
H-Bridge circuit built to drive the stepper motor. The H-Bridge is operated by an Arduino R3 and runs through speed and direction cycles.
Mk.2.3 Motorized: Speed and Direction Test.
Mk.3 Concept: Monolithic Crankshaft Design
Mk.3 Concept System with Monolithic Crankshaft
Mk.3 Concept Motion Study
Cuttlefish Experimental Marine Propulsion System
The Cuttlefish Project is an experimental system that serves to explore alternative methods of propulsion for underwater vehicles. The Cuttlefish system employs biomimetics to duplicate the sinusoidal wing motion to generate thrust, which are seen in batoids such as cuttlefish and rays.
Role |
Co-Designer, Lead Manufacturing Engineer |
For |
NextGen Aeronautics |
Designed Through: |
Solidworks 2013 |