Waterjetting the base and top plate of the robot.

Waterjet at work

Using the edge finder to prep the Mid-Support wall for drilling operations along the edges.

I present to you; Viseception. The worst workholding I’ll probably ever do in my life.

Turning the exterior of the 20 pound steel drum. A boring operation was followed to ensure the drum will be balanced during operation. The drum is estiamted to spin at approximately 10k RPM, so it is critical that the center of gravity is coincident with the rotational axis.

Post turning, the aluminum pulley core is a perfect slip fit.

Broaching the pulley core for shaft and keystock to fit inside

Custom pulley machining on the lathe.

Facing S7 tool steel, which will be the implemented as the weapon teeth on the spinning drum assembly.

Laying out the parts to see how assembly will proceed. The side of the robot is armored with 1095 Blue Tempered Spring Steel plates.

Tapping the frontal arm blocks for armor mounting

Completed frontal arm blocks

Partial assembly with armblocks

Abrasive Resistant (AR450) Steel mounted on the arm blocks. As seen, some dimension erros have been made…

Victor 885 motor controller closeup

Power switches for weapon and drive systems. For connectors, 45A rated PowerPole connectors were primarily used.

We used a Hi-Tec Minima 6T receiver to control the motor controllers for our design

The blue LED strip functions as a power indicator light, and also adds an awesome aesthetic aspect to the robot

DracUCLA assembled and wired up; READY FOR COMBAT

DracUCLA Reborn

DracUCLA Reborn is the flagship design for UCLA Battlebots for the 2015 Robogames competition. The design is a Horizontal Drumspinner in the Lightweight (60lb) class. With over $4000 in parts and 200+ hours of fabrication, DracUCLA Reborn is the most advanced and ambitious design taken on by the team.
This revision of DracUCLA consists of several experimental aspects, including exotic metals such as AR450 Steel and 1095 Blue Tempered Spring Steel for armor, and precision heat-treated (Rockwell 54C) S7 Tool Steel weapons that are theoretically optimized for hardness and impact resistance.
The robot is powered by two large Li-Po batteries that have a capacity of 5Ah each, and boast an output of 250A continuous current at 22.2 Volts.

Role
Co-Designer, Co-Machinist, Lead Electrician
For
UCLA Battlebots