Perspective view of the Monocoque design.

Primary roughing toolpath simulation

Secondary roughing toolpath simulation. The roughing toolpaths were manually separated into two parts in order to remove as much bulk material as possible in the shortest amount of time.

Stock metal loaded into the Haas VF2SS

Support rib structure toolppath

Post machining support rib closeup

Built-in motor mount toolpath

Post machining motor mount closeup

Bottom view

Engineering Drawing annotations made for programming toolpaths.

OOPS! Valuable Lesson Learned:

Always use endmills with a smaller radius than the radius of the arc being machined to avoid poor surface finishes.

Monocoque Combat Robot Concept

The Monocoque Chassis Concept prototype is a design made for small scale combat robots. The design revolves around the premise of creating the primary structure from a single piece, which gives superior structural properties and allows for lower weight. While the design has ultimate strength to weight ratio for a given material, the caveat is resource intensiveness and manufacturing inefficiency.

Some distinct features in the design:
-Constructed from single piece of 6061 Aluminum
-Bored pockets in perimeter for geometric strength and weight saving
-Support ribs for structural strength
-Pocket arcs for structural compliance